Go to :  www. Singermachines.co.uk/indstbooks.htm   ...............I just looked this up and they say its a free download. You might want to have a printer handy. Good luck.

Just type in The name and model and model number and it will take you to a site that has several. I just did it.

I'm guessing you have white specks all over your screen. I went through the same thing. I have a Samsung too.  Take the back cover off the set. Now look for the cooling fan. Should be right there in view. Now look directly in where the fan is blowing the air. Should be right in front of it. You will have to remove the fan and a few other wires{ mine were just the kind that plug in.} and get them out of the way. then you will be at the dlp holder. You will have to remove this to get into the chip. The chip is about a 2x2x1/4 inch squairof steel with a piece of squair glass in the middle. This is your chip. There should be some numbers on it. These are what you look for when you order the new one. I got mine through Ebay. Type in DLP CHIP and the number. Go mine from SHOPJIMMY on Ebay. Be careful Putting it back in. Don't put the fan back in until you have the chip lined up. You have to turn on the tv and see if the picture is lined up with the screen. DON'T LEAVE THE TV ON FOR ONLY A MIN> OR SO>  Just long enough to see the pic. Plug every thing in but don't bolt the fan down. You will have to adjust the chip just a fraction of an inch or so. If I had it here I could do it in 5 mins. Good Luck.

First you need internet access. Mine is verison and I just plug my phone line into the wii. There are only 3 ways to get Netflix. Wii,,,Xbox 360 or Computer. The Wii has its own modem in it to make it internet capable. You will have to call Netflix to get an account set up though. A MUST. Good luck.

You have my pitty.  I just joined a few days ago and every time I went to write an answer the page would freeze up. I was using Internet exp. 8. So I went and downloaded the new version 10 and its free and now I don't have this problem any more. Other than that I cant help.

PCV valves are usually located on one of the valve covers. It will have a tube plugged into it. Usually black rubber, about the size of a pencil or a little bigger. You should be able to pry the valve out with a screw driver or grip it with a pair of pliers and pull it out. Its only about 2 inches long. Most usually don't even have a hose clamp on them, they just push it on.

Most o2 sensors are located just Before the cat converter coming from the manifold. It will have an electrical wire coming from it.

You might try TICKETS .COM

No , once or twice is all you can get. There is a ram that goes down the tube for the pressure with a piece of leather ,usually,at the end of it. When you cock the gun the leather [Gasket} is what seals the tube and forces the air down the tube. It will only take so much pressure no matter how many pumps you give it. Just make sure you give that tube a shot of oil once to keep the leather gasket and the tube lubricated. Otherwise it will dry out and the air you try to pump in will just bypass the gasket.

I did this once before. I presume you want the codes so your remote control will work with your tv. The Philips codes are "03" , "04" , "06" and "12". One of these should work. Do you know how to do it.?