close
    What is the procedure for changing rear drum brakes on an old VW Beetle to disk brakes?

    I just recently purchased a homemade motorcyle trike consisting of a 1981 Honda front end and a 1973 VW Bettle rear end. It runs well but requires a great deal of pressure on the brake pedal (almost standing on the pedal)to stop quickly.

    0  Views: 672 Answers: 1 Posted: 12 years ago

    1 Answer

    1.
    Remove the old Brake Pads
    * 1

    Park your car on a level surface. If you have a stick shift car make sure the car is in gear. Do not set the parking brake. Place blocks in front of the front tires so the car does not move while you are working on it.
    * 2

    Open the hood of your car and locate the master cylinder. If necessary, remove brake fluid until the level in the container is less than half full. A turkey baster is a good tool for this. Put the brake fluid in the plastic container and dispose of it the way you dispose of motor oil.
    * 3

    Raise the rear end of your car with your car jack. Remove the rear tire or wheel assembly.
    * 4

    Remove the parking brake cable from the back of the caliper. Use the pliers to remove the cable clip (restraining clip).
    * 5

    Use the socket wrench to remove the upper mounting bolt from the caliper. If the upper guide pin moves while you do this, use a back-up wrench to hold the upper guide pin.
    * 6

    Rotate the caliper downward, pivoting it on the lower caliper bolt. Remove the inner and outer brake pads from the caliper.
    Install the new Brake Pads
    * 1

    Turn the caliper piston clockwise to retract it into the caliper housing. Insert the new brake pads into the caliper.
    * 2

    Swing the caliper upward and into place. Apply a thin coat of thread locking compound to the bolt and use the socket wrench to tighten the bolt to 271 inch lb. (35 Nm).
    * 3

    Reattach the parking brake cable to the caliper.
    * 4

    Replace the tire wheel assembly. Lower the car to the ground.
    * 5

    Pump the brake pedal a few times to seat the brake pads. Do this before trying to move your car.
    * 6

    Add fluid to the master cylinder container to replace any you removed before you removed the old brake pads.
    * 7

    Season the brake pads by making only gentle stops when you are driving for the first week after you install the new brake pads. Try not to do any hard stopping when you are seasoning the brakes.

    Hope this helps...


    Top contributors in Uncategorized category

     
    ROMOS
    Answers: 18061 / Questions: 154
    Karma: 1101K
     
    Colleen
    Answers: 47270 / Questions: 115
    Karma: 953K
     
    country bumpkin
    Answers: 11322 / Questions: 160
    Karma: 838K
     
    Benthere
    Answers: 2392 / Questions: 30
    Karma: 760K
    > Top contributors chart

    Unanswered Questions

    AAAAAA
    Answers: 0 Views: 4 Rating: 0
    Buy TikTok Followers from Tokmatik
    Answers: 0 Views: 6 Rating: 0
    Tôi có xinh không
    Answers: 0 Views: 16 Rating: 0
    vnq8today
    Answers: 0 Views: 19 Rating: 0
    W88 Zo
    Answers: 0 Views: 19 Rating: 0
    thenewhopemhcs
    Answers: 0 Views: 25 Rating: 0
    > More questions...
    451714
    questions
    719498
    answers
    751716
    users