7 Answers

If you know where the rod coming up from the governor is, try holding it steady at a high idle and not allowing it to get into the bouncing back and forth. Does it want to stall or still rev up? If it is, then there is a possibility of the float sticking, which would cause an uneven flow of fuel to cause fluxuations in RPMs. But, if it holds at an even high idle, then something is wrong in the area of its low idle be too low and causing the engine's governor to try and recapture a proper operating speed.

14 years ago. Rating: 6
Comment this answer Add new comment

Your more than likely overloading your mower grass to high, mower to low or the blades are dull.

14 years ago. Rating: 5
Comment this answer Add new comment

Check your cable were the switch for safety has a compression bottom so,if this not your problem than it something internals
issue ,sorry couldn't help you.

14 years ago. Rating: 5
Comment this answer Add new comment

Could be your idle screw setting is off or the safety switch cable not releasing to it full amount.that the cable that shut off your lawn mower.

14 years ago. Rating: 5
Comment this answer Add new comment

The butterfly or float inside the carb might be sticking and not able to keep a even flow of gas. Try carb cleaner, if it doesn't help, then probably time to rebuild the carb or buy a new one. Also, check your exhaust port to make sure it isn't blocked with debris.

14 years ago. Rating: 4
Comment this answer Add new comment

Sounds like the oil and gas  mix is too lean . The oil and gas you're putting in may not the be one the owners manual recommends. So, read the manual.......and read the trouble -shooting page too. Try priming it, but not too much , before you start it . Might need spark plug and carburetor  work, too. How old is the mower ?

10 years ago. Rating: 0
Comment this answer Add new comment

Viewed dead-on at first glance, the Black Bay Pro does indeed look quite a bit like a 1655 Explorer II. link Which is, by my estimation, no bad thing. The dial is very different in execution, link as is the large guardless crown, but that bezel is such a distinctive and recognizable frame that my mind (and likely yours) immediately jumps to the early Explorer II. In actuality, the dial, which link is matte black and domed in shape, is very very Tudor and definitely of the Black Bay design ethos.

2 days ago. Rating: 0
Comment this answer Add new comment