Karma: 0

I have a RBC30 bushcutter , while using it this weekend it stalled and when i tried pull starting the pull start would not move

i have always used the ryobi 2 stroke mix at 50:1

Answer this

0 Views: 404 Answers: 3 Posted: 14 years ago

Tags: ryobi bushcutter

3 Answers

Headless Man

Karma: 267169

I think JDB is right if you got it to hot can do it to.
It might turn over when it cools down and even start up but more than likely will need a top end overhaul.

14 years ago. Rating: 0
Comment this answer

strop

thanks Randy
your exactly right , I have tried it tonight and managed to get it started but again it stalled
the engine did not feel excessively hot

commented 14 years ago

Headless Man

Rings are stuck I'll bet.
On a two stroke a top end overhaul will fix it.

commented 14 years ago

Headless Man

If you can get it running have the air filter off and spray some WD40 in the carb and try to keep it running for a wile. It will smoke so have it outside and it could free up the rings, a long shot but won't hurt.

commented 14 years ago

JDB

Karma: 107305

It sounds like the engine tied up. make sure if it takes gas/oil mix that's what you used, straight gas will seize the motor up

14 years ago. Rating: 0
Comment this answer

marcus

Karma: 0

the motor is probally seized try taking out the sprk plugs and pull starting it . If the pull starter still does not move the engine is definetely fucked

14 years ago. Rating: 0
Comment this answer

Top contributors in Garden & Landscape category

ROMOS
Answers: 115 / Questions: 0
Karma: 7485

country bumpkin
Answers: 93 / Questions: 0
Karma: 6720

Colleen
Answers: 139 / Questions: 0
Karma: 3360

jhharlan
Answers: 64 / Questions: 0
Karma: 3330

> Top contributors chart