1 Answer
Things You'll Need
Automotive jack
Jack stands
Wheel chocks
3/8-inch ratchet
Metric socket set
Replacement crank angle sensor
Instructions
1
Park the Commodore on a flat surface and turn off the engine. Engage the emergency brake and pop open the hood. Allow the vehicle to cool for at least one hour.
2
Place wheel chocks behind the rear wheels and lift the front of the vehicle using an automotive jack. Lower the vehicle down onto jack stands and remove the jack.
3
Crawl underneath the engine and locate the crank angle sensor. It is in the center of the engine block, between the firewall and the engine. It is made from black plastic and has a two-wire connector attached to it.
4
Disconnect the sensor's electrical connector and remove the bolt holding the sensor to the engine block using a 3/8-inch ratchet and a metric socket. Remove the sensor from the block using a twisting/pulling motion.
5
Install the new sensor into the block using a twisting/pushing motion. Reinstall the sensor's retaining bolt and reconnect its electrical connector.
6
Raise the front of the vehicle using the automotive jack and remove the jack stands. Lower the vehicle to the ground. Start the engine and verify that it operates properly.
Read more: How to Replace a Crank Angle Sensor in Holden Commodore | eHow.com http://www.ehow.com/how_7971145_replace-angle-sensor-holden-commodore.html#ixzz2MpbTR39I
11 years ago. Rating: 0 | |