close
    1. Home
      2. ›
    2. Home & Garden
      3. ›
    3. Other - Home & Garden
      4. ›
    4. solo kat 471 stalls after running full throttle for a few minutes. Fuel lines replaced but still seems to be starved for gas. Pushing the primer bulb causes engine to stop. Any suggestions?
    solo kat 471 stalls after running full throttle for a few minutes. Fuel lines replaced but still seems to be starved for gas. Pushing the primer bulb causes engine to stop. Any suggestions?

    Answer this
    0  Views: 452 Answers: 1 Posted: 11 years ago
    freddy the rabbit

    the float is to low in carb it could mean bad seat so replace needle and seat in carb
    Commented 11 years ago
    Comment this question

      1 Answer

      Freddy has my answer. I'd also point out that pushing the primer while the engine is running with a bad float is just flooding the engine which is why it is stalling. 

      11 years ago. Rating: 0
      Comment this answer



        Did this answer your question? If not, then ask a new question.

        Top contributors in Other - Home & Garden category

         
        ROMOS
        Answers: 108 / Questions: 0
        Karma: 6300
         
        country bumpkin
        Answers: 72 / Questions: 0
        Karma: 4950
         
        Colleen
        Answers: 143 / Questions: 0
        Karma: 3385
         
        Benthere
        Answers: 6 / Questions: 0
        Karma: 3150
        > Top contributors chart
        452310
        questions
        719720
        answers
        754213
        users