close
    1. Home
      2. ›
    2. Uncategorized
      3. ›
    3. I have a Power Distribution Unit [480 V 60Hz 3ph] Rated at 200HP that drives a 150HP remote motor load. What HP Rating info should be applied to the PDU Nameplate [for mains connection]?
    I have a Power Distribution Unit [480 V 60Hz 3ph] Rated at 200HP that drives a 150HP remote motor load. What HP Rating info should be applied to the PDU Nameplate [for mains connection]?

    I have a Power Distribution Unit [480 V 60Hz 3ph] Rated at 200HP that drives a 150HP remote motor load. What HP Rating info should be applied to the PDU Nameplate [for mains connection]?


    The NEC has nameplate rating requirements for motors, motor controllers and such, but does not seem to address this.  Arc flash calculations would take into account a motor acting like a generator during coast-down following an interrupted fault.  Thanks for any guidance you can offer.

    Answer this
    0  Views: 1324 Answers: 1 Posted: 13 years ago
    Tags: marking labelling rating electrical
    Comment this question

      1 Answer

      Sorry but though we do our best to answer questions here, we are a general questions and answer site only and this is beyond our knowledge base. I'm not even sure where to direct you for help. I apologize that we could not be of any help. 

      13 years ago. Rating: 1
      Comment this answer



        Did this answer your question? If not, then ask a new question.

        Top contributors in Uncategorized category

         
        ROMOS
        Answers: 18061 / Questions: 154
        Karma: 1102K
         
        Colleen
        Answers: 47269 / Questions: 115
        Karma: 953K
         
        country bumpkin
        Answers: 11322 / Questions: 160
        Karma: 838K
         
        Benthere
        Answers: 2392 / Questions: 30
        Karma: 760K
        > Top contributors chart
        537304
        questions
        771174
        answers
        888180
        users