close
    where can I find a tool to put a slot along a table edge to install plastic edge?

    0  Views: 250 Answers: 4 Posted: 9 years ago

    4 Answers

    You can check a dremel (Sears, Home Depot or Lowes, Target, Walmart) to see if it uses a cutting tool big enough for what you want to do. If not, purchase a router at Sears, Home Depot or Lowes. Ask the floor person which bit you need for the job you want to do. Practice first before you use the router on the table.
    A skill saw I think would be best for the job, you can adjust it to the exact depth, and use the guide to run it along your line. Pre-test it on a sheet of plywood or something, there are good suggestions up there as well, hope this helps?
    A router with a saw bit will do the job better than a Dremel you can adjust the depth of your cut but you also have to get a saw blade that is near the thickness of the plastic edge.
    Ask a laninate installer


    Top contributors in Uncategorized category

     
    ROMOS
    Answers: 18066 / Questions: 153
    Karma: 1101K
     
    Colleen
    Answers: 47274 / Questions: 115
    Karma: 953K
     
    country bumpkin
    Answers: 11316 / Questions: 160
    Karma: 838K
     
    Benthere
    Answers: 2380 / Questions: 30
    Karma: 759K
    > Top contributors chart

    Unanswered Questions

    Oneplus Phones Australia
    Answers: 0 Views: 2 Rating: 0
    Tattslotto for Sale Melbourne
    Answers: 0 Views: 4 Rating: 0
    > More questions...
    446064
    questions
    716528
    answers
    654698
    users