1 Answer

Instructions
1
Drain the fluid from the cooling system.

2
Disconnect the negative battery cable.

3
Remove the clutch assembly and disconnect the wiring harness retainer from the water pump when working with either the 3.7L & 4.7L Engines. Also disconnect the lower hose. Remove the fan assembly and shroud and keep the fan clutch upright to keep the silicone fluid from leaking if you plan on reusing it.

4
Take out the accessory drive belt, the lower radiator hose and the heater hose with the tube, the bypass hose and the water pump pulley when working with the 3.9L, 5.2L and 5.9L Engines.

5
Remove the engine cooling fan as well as the coolant recovery bottle and washer bottle, the A/C compressor and alternator brace, the fan shroud, the idler pulleys, the radiator and heater hoses and the belt tensioner when working with the 5.7 engine.

6
Take out the washer solvent bottle, the engine cooling fan and shroud, the upper radiator hose, the accessory drive bet, the lower radiator hose and heater hose, the water pump pulley and the bypass hose when working with an 8.0 engine.

7
Remove the water pump and install the new pump, tightening the bolts to 18 foot pounds.

8
Reinstall and connect the rest of the system in reverse order and reattach the negative battery cables.

9
Refill the cooling system and start the engine. When the engine gets to normal working temperature, check the system for leaks.

Read more: How to Replace the Water Pump in a Dodge Ram | eHow.com http://www.ehow.com/how_4508674_replace-water-pump-dodge-ram.html#ixzz2Haojf7BM