close
Answers: 209
how to install control arm bushing on a 2002 chevy trail blazer
Answers: 2 Views: 363 Rating: 1 Posted: 11 years ago

control arm bushings are pressed off and back on with the help of a press machine or an air hammer that can apply a lot of force. at home on the ground you can only replace entire control arm but a repair shop can only do the busings properly. if you will try a regular hammer ,you will more likely destroy the bushings or distort them where it won't fit back on easily.good luck.                                    one more thing   , be careful with the spring and secure it well even if you do the entire control arm. if it comes out of its' place it cxan take your head off or at least lose some fingers. so just be careful and use common sence when it comes to your safety.

Rating: 2 Posted: 11 years ago
15 yrs ago I was engaged to a man. I ended the relationship after about a year. To be honest, I was just scared. No one in my family has a healthy marriage. The break up ended with alot of hatred on his part. I made a huge mistake and want to rekindle things. He's divorced and out of state. Should I talk with him and what do I say.
Answers: 1 Views: 1050 Rating: 1 Posted: 11 years ago

all you can do is tell him exactly what you said here and prove to him how sorry you have been all these years. after that just sit back and wait for him to answer. it may take some time for him to do so but if he does not give you a sign of any kind then you must move on. you have done your part to correct this mistake but do not expect anything just because you stuck your neck out there. the only good thing you should get out of this is your piece if mind after you told him how you feel. after that if he decides to contact you ,it will be the icing on the cake for you.good luck.

Rating: 3 Posted: 11 years ago
check engine light code 1494
Answers: 1 Views: 493 Rating: 0 Posted: 11 years ago

you need to give the make, model and engine size first before anyone can help. try again.

Rating: 1 Posted: 11 years ago
Won't start and says doesn't detect and FOB
Answers: 1 Views: 492 Rating: 1 Posted: 11 years ago

you should  say what kind of vehicle you have first of all. if the vehicle can not detect the key fobe then you should install new batteries before you look for any other problem with the system. if you have done that already then a repair shop or dealer needs to check for fault codes in the system. not much you can except maybe try your second remote if you have one.good luck

Rating: 1 Posted: 11 years ago
how to install rear disc brakes
Answers: 1 Views: 406 Rating: 1 Posted: 11 years ago

remove two bolts that hold the caliper to caliper bracket and pry the caliper off with a pry bar or fairly big screw driver, push the piston in with a pair of chanel locks,clean and lubricate caliper slides and pay attention to the old brake pads to see exactly the way the pads are facing. there is a left and a wright on the pads to the way it mounts to the caliper bracket. hope this helps.

Rating: 2 Posted: 11 years ago
6 gallons and 2 quarts - 5 gallons and 3 quarts =?
Answers: 1 Views: 492 Rating: 1 Posted: 11 years ago

6x4+2 is26 quarts - 5x4+3 is23 qts so it equals 3 quarts

Rating: 1 Posted: 11 years ago
my radio wont work in my 1996 dodge dakota truck
Answers: 3 Views: 277 Rating: 2 Posted: 11 years ago

the problem will be in the radio unit itself since you have done the basics. outside the radio there is nothing else to check or do.sometimes by tapping on the unit may come back on for a while.

Rating: 2 Posted: 11 years ago
i have bled rear brakes and the brake pedal goes soft after a short time
Answers: 1 Views: 1505 Rating: 0 Posted: 11 years ago

it sounds as if the master cylinder seals are going bad by allowing fluid to pas in between the piston rod and the seals. anyway replace the master cylinder and start bleedind the brake system with the r.r wheel first, l.r second, r. f  third and L. F wheel last. at times you may do it twice if air is not coming out easily.good luck

Rating: 2 Posted: 11 years ago
where is fuel pump on 1993 mercedes benz 190e 2.3
Answers: 1 Views: 841 Rating: 1 Posted: 11 years ago

it is between the back seat and half way in the trunk area. remove the rear seat cushion and there should be a plate or cover that  the pump is located.

Rating: 1 Posted: 11 years ago
whats the fuel pressure in a 1996 dodge ram
Answers: 1 Views: 654 Rating: 1 Posted: 11 years ago

it should be around 36 to 50 psi. most original fuel pump modules on dodge or chrystler vehicles the original fuel pump goes bad within 100k miles. other fuel pumps may linger some before it quits . some owners do not replace the fuel filter on regular bases and it takes out a lot of the pumps life.

Rating: 1 Posted: 11 years ago

Top Contributors

 
ROMOS
Answers: 39019 / Questions: 245
Karma: 2300K
 
Colleen
Answers: 90249 / Questions: 368
Karma: 2042K
 
country bumpkin
Answers: 26279 / Questions: 276
Karma: 1665K
 
Benthere
Answers: 4136 / Questions: 80
Karma: 1556K
> Top contributors chart
452120
questions
719645
answers
753260
users